Proxima ASA DP8200x - Manual (Page 10)

8
If you prefer connecting your computer to the projector with an optional
M1-D cable, connect one end of that cable to the M1 port on your computer,
and connect the other end to the Computer 1 connector on the projector.
You can control the projector from an LCD control panel or computer by
connecting an RS-232 cable to the projector’s Serial connector. Specific
RS-232 commands can be found in the Service and Support section of our
website.
The projector can be managed by ProjectorNet networking software
through its Network connector.
Contact an authorized dealer or visit our website for information on
ProjectorNet.
connect M1-D cable
computer 2 network
audio in L
computer in
trigger
monitor out
serial control
R audio in
computer 1 USB mouse
computer 3 I
O
connect RS-232 cable
computer 2 network
audio in L computer in
trigger
monitor out
serial control
R audio in
computer 1 USB mouse
computer 3 I
O
Network computer 2 network
audio in L computer in
trigger
monitor out
serial control
R audio in
computer 1 USB mouse
computer 3 I
O
connect network cable