Panasonic DP-8025 - Manual (Page 108)

Pre Installation Information
108
To install your machine as SMTP Mail Server, the following network parameters need to be programmed on
your network, and on your machine.
• TCP/IP Address of your machine
• TCP/IP Subnet Mask of your machine
• TCP/IP Address of the Default Gateway
• Host Name
• TCP/IP Address of the DNS Server (if not available, see Note 2)
• Email Address of your machine (See Note 1)
• Name, or IP Address of the Default SMTP mail server
• SMTP Authentication Name (when the authentication with the SMTP server is required)
• SMTP Authentication Password (when the authentication with the SMTP server is required)
Email (from your machine to a PC) and Direct Internet Fax XMT Transmission
Email (from a PC to your machine) and Direct Internet Fax XMT Reception
NOTE
1. To function as SMTP mail server, your machine's email address must include its unique Host
name within your company domain. This unique Host name must be registered within your
network’s DNS (Domain Name System) server. Ex: [email protected]
2. By default the machine requires the IP Address of the DNS Server, and prompts you to enter
the SMTP Server Name.
If the DNS Server is not available, change the 27(DNS Server Address) of General Settings to
"No".
Press , Input Key
Operator’s password, .
Setup as SMTP Mail Server
[email protected]
SMTP01.panasonic.com
(SMTP Mail Server)
POP02.panasonic.com
(POP Server)
Gateway(Router)
[email protected]
SMTP
POP3
Direct Internet Fax XMT
[email protected]
[email protected]
SMTP01.panasonic.com
(SMTP Mail Server)
Gateway(Router)
[email protected]
SMTP
Direct Internet Fax XMT
[email protected]
FUNCTION GENERAL SETTINGS 09 Key Operator Mode
OK 27 DNS Server Address