PS Audio PD 3.5 - Manual (Page 5)

Front Panel
Power On/Off
Pressing the Power button will toggle the unit
from standby mode to operate mode. When
in operation mode the Director will output AC
power to any of the three zones that are set to
the delayed (DL) or switched (SW) position on
the rear panel. The front panel logo will illumi-
nate when the Director is on.
The Power Director 3.5 will indicate protection
circuitry failure. In this condition the front panel
logo will blink and no power will be provided
from the rear panel outlets regardless of the
position of the power mode switches. If this situ-
ation persists contact service at PS Audio.
Note: any zone whose corresponding rear
panel switch is in the “ON” position will continue
to pass power and provide surge protection
even if the director is in standby mode.
DC Trigger
The DC input trigger mini-jack (3.5 mm) will con-
trol the power status of the Director. Connect
the Director to the product which will control
the power status of the Director with a mini-jack
cable (male-male). The Director will switch on
and off with the power status of the connected
product.
The trigger will respond to DC voltage over the
range of 6 - 18 Volts. The Director will be on
when voltage is present and will switch off when
the voltage is removed.
Logo trim tool
The Logo trim tool is used to adjust the potenti-
ometer which controls the illumination intensity
of the PS logo.
Locate the hole in the bottom of the Director. It
is directly below the PS logo. Insert the Logo
trim tool. Twist clockwise to increase the illumi-
nation of the PS logo. Twist counter-clock wise
to decrease the illumination. The logo can be
dimmed entirely.
5