Pella HINGED PATIO DOOR - SOUTHWESTERN WALL WITH HARD COAT STUCCO 80KM0103 User Manual
Page 4
'
PRE PUNCHED
( Carefully open the door(s) and remove all shipping spacers.
Note: Be sure to remove the spacers from the bottom edge of the door panel.
Double doors with center latch:
Designer Series Only: Use the construction handle to operate the active door
HANDLE
Architect Series Only: Use the construction handle to operate both the active
and passive door panels.
I. Out-swing doors: Place a dab of sealant in each of the pre-drilled holes in the bottom of the door frame, then insert a
)
)NSTALL
J. On center latching (double) doors: Place shims at the top of the door frame above
THE
*
above the astragal in the center of the unit.
Note: Step K does not apply to center hinged doors.
K. On each hinge, starting at the top, insert a 3" long screw
OPEN
L. Check door operation.
-AKE
M. Adjust the reveal if needed.
Architect Series and Designer Series only:
TURN
Note: DO NOT adjust the hinge with the top and bottom screws loose; this could force the hinge to adjust beyond
its design capability which can cause the hinge to bind, damage the hinge and/or pull out the screws. A 3/4 turn of
the center screw provides approximately 1/16" adjustment.
Note: For more issues with the adjustable strike latching, go to the troubleshooting section at the end of this instruction.
ProLine Series only: Plastic shims located behind the hinges may be removed to adjust the reveal between the door panel
and door frame. Additional hinge shims may be added if required.
N. On doors with a lock strike in the side,
ROUGH
Note: This step does not apply to center latching double doors.
O. Install a #8 x 3" flat head corrosion resistant screw
door frame, on the latch side of the frame.
&YUFSJPS
У
У
*OUFSJPS
У
У
У
У