Set up the rip function – Paradyne 1740 SHDSL User Manual
Page 40
1740 SHDSL 2/4-Wire Router User’s Guide
Delete:
STEP 1: Select the entry you wish to delete from the List of Static Routes
STEP 2: Change the parameters
STEP 3: Click on the Delete button
7.2
Set Up the RIP function
To enable the RIP, complete the following steps:
STEP 1: Click Routing Setup from the Basic menu bar
STEP 2: Select On in the Rip Status field.
STEP 3: Select a RIP Version (Version 1 or Version 2) from the Version field.
STEP 4: Click Apply to submit the settings.
To configure the advance functions of the RIP, click on the RIP tab on the main screen, and configure the
requested parameters.
Mode:
Select Enabled
Version:
RIP version 2 or version 1
Authentication:
none: no authentication code is required.
PlainText: an authentication code is required. You should also fill in
the Authentication Code field to assign a password.
MD5: an authentication code is required. You should also fill in the
Authentication Code field to assign a password.
40 July 2004 1740-A2-GB20-00