Panasonic KX-PS8000 - Manual (Page 90)

90
■Reset Calibration
Setting YES resets the current settings back to the default settings.
Note:
BThe color density setting affects the average life of toner.
System Setting
Configures the printer.
■Energy Star
To conserve energy and operating cost, this printer is provided with a
programmable power save feature. Printer is factory set with the power save
feature turned on.
If Energy Star is enabled, the printer enters the Energy Star mode when the printer
is idle for 30 minutes.
■Auto Continue
With the Auto Continue set to ON, the printer automatically recovers from the
following error conditions if no recovery operation is done for 10 seconds.
BMemory Overflow
BSCSI communication error
■Data Timeout
With the Data Timeout set to ON, the printer automatically returns to Ready status if
the printer does not receive any data from a computer within the time period set in
this selection (30 to 240 seconds).
Network
Sets the addresses used in TCP / IP Protocol. During setting, use the
I/CANCEL
button to move the cursor and the
F/CONTINUE button to increase the numerical
value.
Maintenance
Displays the page count of the printer and the consumption of supplies. It also gives
you an idea when the following supplies need to be replaced. The following table
shows the average life of each supply, which is based on a 5% image area and
standard density. Refer to
pages 98 and 99 for details.
* When a supply is replaced with a new one, the printer will automatically reset the
page counter for that supply to 0.
15,500 pages
Average life
Oil Supply Roll *
Basic Operations
Supplies
Imaging Unit * 60,000 images
Transfer Unit 80,000 pages
Fuser Unit * 31,000 pages