Plinius Audio SB-301 - Manual (Page 15)

13 POWER AMPLIFIER
CONNECTING THE MAINS SUPPLY
Firstly, check that the mains supply voltage printed on the rear of this amplifier is
similar to the mains supply voltage in your area. If in doubt, please consult your
Plinius dealer. Mains supply power connection is via the plug-in lead supplied with
your Plinius SB-301 MKII.
Check the wall outlet is switched OFF, then connect the local mains plug end of the
lead to the wall outlet. Check the SB-301 MKII is switched OFF, and connect the IEC
end of the cable to the IEC socket at the back of the SB-301 MKII. With the cord fully
connected, switch the wall outlet ON.
Now that your Plinius SB-301 MKII is configured correctly, switch the power switch on the
rear panel to ON. The display LED will cycle in brightness for approximately ten seconds
as the internal circuitry stabilises. Use the MUTE switch on the front panel to take the unit
out of MUTE and you can now enjoy your new Plinius SB-301 MKII Power Amplifier.
NOTE: This unit must be connected to a mains socket outlet with a protective earthing
connection. The wall outlet socket or SB-301 MKII mains switch must be accessible at
all times in case of emergency.
WARM-UP PERIOD
You will find that the Plinius SB-301 MKII will become noticeably ‘purer’ in sound
after being on for a period of time. We recommend waiting at least 24 hours before
expecting the best quality of sound reproduction from your amplifier.