PLUS Vision HE-3100 - Manual (Page 18)

E – 18
Turning ON or OFF Main Power
POWER
ON
OFF
STATUS POWER /
POWER
ON
OFF
POWER / STATUS
Main power ON
Main power OFF
4 Turning ON or OFF Main Power
Before turning the main power, check that the power is switched off the equipment that is to
be connected and the connection is finished.
To turn on the main power:
Press the POWER switch down until it is in the depressed po-
sition.
On condition
Off condition
Light in orange
Indicator OFF
To turn off the main power:
Press the POWER switch until it is in the protruded position.
Attention!
• Do not switch off the main power or disconnect the power cord unless the POWER/ indicator is lit orange. Doing so
could shorten the life of the lamp or possibly cause the unit to malfunction.
When the unit is set to ON (and the LED is not lit) using the menu [Setup]
→
[LED] items, the indicator flashes green for
1 minute, then goes off. Likewise, at this time the main power should not be switched off.
• To save power, switch off the main power when not in use. When the main unit or remote control ON/STANDBY button is
used to set the projector to the standby mode (POWER/ indicator is lit orange), the cooling fan continues to operate.
5 Turning ON or OFF Power
The ON/STANDBY buttons of the main unit and the remote control have the same function. A description using the main unit button
is provided here.
To turn on the power:
Press the ON/STANDBY button for about 2 seconds. The projection
screen will brighten in about 40 seconds.
Note: When the unit is set to off (and the LED is not lit) using the menu [Setup] →
[LED] items, the indicator flashes green for 60 seconds, then goes off.
Setting standby mode
Press and hold down the ON/STANDBY button for about 2 seconds.
To switch on the power again, leave at least 60 seconds before doing
so.
ON / STANDBY
ON / STANDBY
STATUS
POWER / STATUS STATUS
POWER
STATUS
STATUS
STATUS POWER / POWER / POWER /
POWER / POWER /
Light in orange
Light in orange
Light in green
Light in green
Power ON
Standby
Flashing orange
Flashing green
Flashing for 60 seconds
Flashing for 60 seconds
Note:
* When a signal is not being input while projecting onto the projection screen, "No Signal" is displayed to indicate the condition. The background color of the screen
will be blue at this time. The background color can be changed to black by via [Setup] → [Background] of the menu. → Page E-34"Background Color Settings"
* When the power is switched on, the input selection and aspect selection conditions will be the same as the conditions that existed when the power was switched
off.
* Adjustments and setting values that were made via menu operations will be stored even when the main power has been switched off or the power cord has been
disconnected.
When the power won't switch on
* When the internal temperature is abnormally high, the power will not be switched on to protect the equipment. Wait for a while and then try switching on the power
again.
* Should the STATUS indicator be lit or flashing, please see "When the STATUS Indicator Is Lit/Flashing" on Page E-39.
POWER ON
OFF
PO WE R/
ST AT US ON /ST AN DB Y AS PE CT SO UR CE
POWER/ indicator
ON/STANDBY button
POWER switch