Panasonic AJ-HD130DCP - Manual (Page 28)

28
OPERATION
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of setting
The underlining denotes the factory mode.
Setup Menus
154 AUTO BACK
0000
0001
0002
OFF
REC-P
ALL
For setting the operation method used for the frame-to-frame continuity
function. (This item activates the AUTO BACK function to rewind the tape
for several seconds in order to ensure a smooth continuity between the
recorded images.)
0: No AUTO BACK operation.
1: In the REC PAUSE mode, the AUTO BACK function is activated, and
the tape stops in the recording standby mode. (When PAUSE is
released, the tape runs up and recording starts.)
2: In addition to the menu item No.0001 (REC-P) function, the AUTO
BACK function is activated in the REC PLAY mode, the tape runs up
immediately, and recording starts.
160 MEMORY MODE
0000
0001
0002
0003
OFF
M-STOP
REPT1
CONT
For setting the repeat playback mode.
0: No repeat playback (normal operation).
1: The tape stops near the BEGIN point when it is fast forwarded or
rewound.
2: When the tape reaches the END point, it is rewound to the BEGIN point
where it stops.
3: When the tape reaches the END point, it is rewound to the BEGIN point
and played, and this process is repeated.
163 REPT MODE
0000
0001
0002
FREEZE
BLACK
SW
For setting what image is to be output when the tape returns to the BEGIN
point in the repeat playback mode.
0: The tape returns to the BEGIN point while the playback image at the
END point remains frozen.
1: The tape returns to the BEGIN point while the picture remains black.
2: The tape returns to the BEGIN point in accordance with the TAPE/EE
switch setting.
<Note>
If the END point is set at the tape end when “0: FREEZE” has been
selected, the playback image will not be frozen properly. Set the END
point within the range of the tape where images are recorded.
161 BGN PRESET
(CTL or TC) For setting the BEGIN point in the repeat playback mode. The counter
display mode is set to either TC or CTL by the COUNTER button.
When the BEGIN point is not set, “--:--:--:--” appears on the display, and
the beginning of the tape serves as the BEGIN point.
162 END PRESET
(CTL or TC) For setting the END point in the repeat playback mode. The counter
display mode is set to either TC or CTL by the COUNTER button.
When the END point is not set, “--:--:--:--” appears on the display, and the
tape end serves as the END point.
180 BATTERY SEL
0000
0001
0002 NiCd12
NiCd13
NiCd14
For setting the battery type.
0: 12 V type of battery
1: 13 V type of battery
2: 14 V type of battery