Panasonic PV 9D53 - Manual (Page 17)

17
DISPLAY
Press DISPLAY to display the
current information on the screen.
Press DISPLAY again to clear the
call display.
CHANNEL
Press and release CH or . The
channel automatically stops at the
next channel set into memory.
For proper operation, before select-
ing channels, they should be set into
the memory. See pages 20 and 21
“To memorize channels”.
R-TUNE
This button allows you to go back to
the last channel selected by press-
ing R-TUNE. Press R-TUNE again
to return to the last channel you
were watching.
SLEEP
To set the TV/DVD to turn off after a
preset amount of time, press SLEEP
on the remote control. The clock will
count down 10 minutes for each press
of SLEEP (120, 110, ...10, 0). After the
sleep time is programmed, the display
will appear briefly every ten minutes
to remind you that the sleep timer is
operating. To confirm the sleep timer
setting, press SLEEP and the remain-
ing time will be displayed for a few
seconds. To cancel the sleep timer,
press SLEEP repeatedly until the dis-
play turns to 0.
SLEEP
120
STEREO SAP CH 012
SEL. MONO+SAP • Channel number or VIDEO mode
• Stereo or SAP (second audio
program) audio status
• Audio output status
Press MUTE to switch off the sound.
The TV/DVD’s sound will be silenced
and “MUTE” will briefly appear on the
screen. The sound can be switched
back on by pressing this button
again or one of the VOL + or –
buttons.
MUTE
MUTE
NOTE: CH ▲ or ▼ on the remote con
trol does not operate in DVD
mode.
5E90501A P12-17 21/4/03, 11:57 PM 17