Connecting the input/ output terminals, Rear panel, Front panel – Pioneer DJM-350 User Manual
Page 8
8
DRB1502-E
En
8
Connecting the input/ output terminals
! When creating a DVS (Digital Vinyl System) combining a computer, audio interface, etc., be careful in connecting the audio interface to this unit’s
input terminals and in the settings of the input selector switches.
Also refer to the operating instructions of the DJ software and audio interface.
Rear panel
AC IN
AUDIO
OUT
R
L
CONTROL
USB
MASTER OUT
CH-2
1
L
R
2
PHONO
CONTROL
SIGNAL
GND
L
R
CD
CH-1
AUX
MIC
PHONO
CONTROL
L
R
L
R
CD
Microphone
Component, amplifier,
powered speaker, etc.
To audio input terminals
Audio input section
Audio output section
Audio cable
Audio cable
Audio cable
To audio
output terminals
To audio
output terminals
Control cord 1
Ground wire
To ground
wire terminals
Audio cable 2
Microphone
cable
To microphone
Portable
audio
device
Analog player
DJ player
Example:
CDJ-350
Power cord (included)
To power outlet
R
L
R
L
R
L
R
L
R
L
1
To use the fader start function, connect a control cord (page 11).
The fader start function can only be used when connected to a Pioneer DJ player.
2
A portable audio device can be connected using an RCA pin - mini-plug (Ø 3.5 mm) converter cable (page 12).
Front panel
Headphones
Headphones cord