Panasonic CF-30KTPAXxM - Manual (Page 62)

9-39
Attach the HDD Cushion (Yellow)
Attach the HDD Cushion (Yellow)
Attach the
HDD Cushion
(Black)
Attach the
HDD thermal Plate
1~3
1~3 1~3
0~1
0~1
1~3
HDD Cushion
(Black)
* Notes:
HDD Thermal Plate
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Do not bend it at a sharp
angle to put natural R.
When attaching HDD Cushion Plate and HDD Cushion (Black),
set the bending part of the metal plate up.
Longer Direction
Metal Plate
*Ensure the
direction is right.
(lateral)
Put the edge on the same line.
Difference: 1
(15)
0–1
I get a gap for
breathing hole
securement.
To the level of attaching
closely in this range
A-A SEC B-B SEC
A
(2)
(0)
(20)
HDD Side Damper
is installed
HDD Side Damper
B B
A
0~0.5
HDD Bottom Case Ass’y
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Right and left position: Match to the center
Top and bottom position:
Lower Case
(Entire Circumference)
Paste the cushion with pressing
in the direction of arrow.
Make the black damper get into the
both sides of the green damper.
Match the edge of the base
material transparent sheet
to the bottom side