Panasonic BM-ET300AE - Manual (Page 18)

18
■ Installation
Cautions:
• Mount the iris camera to the flat and firm wall with the
supplied mounting bracket. Besides, secure the iris
camera and bracket with the supplied mounting screw,
at the time of the mounting. Otherwise, it may cause
dropping, trouble or injury.
• Check if the wall has enough strength for mounting and
no dents. Otherwise, the rear tamper detection switch
will not be pressed and the tamper detection mode will
be activated.
The iris camera can be mounted over the wall as
described.
1. Bury the anchor into the wall. (Refer to the illustration of
"Dimensions of the Mounting Bracket".) The anchor bolt
should meet the standards shown in the illustration.
Notes:
• Wall's capacity is 100 N or more.
• Anchor bolt's capacity is 100 N or more (per one).
• Take a side view to make sure that all the mounting
hook holes of the iris camera have been hung over the
mounting hooks of the mounting bracket. If the rear
tamper detection switch is not be pressed, the iris cam-
era may not work properly.
Equivalent to
anchor M6
Washer
Mounting bracket
1 mm {0.04 in.} (D)
Anchor bolt
6 mm {0.24 in.} or less
φ13 mm
{0.51 in.}
or less
φ11.5 mm
{0.45 in.}
or less
Wa
ll
2. Attach the iris camera to the mounting bracket.
(1) Attach the supplied
mounting bracket to the
wall, and then attach the
iris camera to the
mounting bracket.
(2) Hang the mounting hook
holes of the iris camera
over the mounting hooks
of the mounting bracket.
(3) Fix the iris camera and
mounting bracket with the
supplied mounting screw.
(4) Connect the cables to the
iris camera.
Anchor bolt
Mounting hook (x4)
Mounting
bracket
Video cable and power cable
(Refer to p. 16 for the
specifications of these cables.)
Note: If you lay cables along a wall surface, replace the cable hole
cover on the bottom of the iris camera. (Refer to p.12.)
192 mm {7.56 in.}
150 mm {5.90 in.}
109 mm {4.29 in.}
201mm {7.91in.}
158.5 mm {6.24 in.} 144.3 mm {5.68 in.} 178.5 mm {7.03 in.}
41 mm
{1.61 in.}
30 mm
{1.18 in.}
52.5 mm {2.06 in.}
73.5 mm
{2.89 in.}
83.7 mm {3.29 in.}
50 mm {1.97 in.}
119 mm {4.68 in.}
20 mm
{0.79 in.}
27 mm
{1.06 in.}
16 mm
{0.63 in.}
8 mm {0.31 in.}
Mounting
hook (x4)
Projection of the tamperproof switch
Dimensions of the mounting bracket
Tamper detection
switch
Wall Wall