Planet Technology Planet Intelligent Gigabit Ethernet Stackable/Routing Switch WGSW-2402A - Manual (Page 94)

- 86 -
Use Broadcast/Multicast: Specify how the routing table is sent out. RIP-1 can only use
broadcast. RIP-2 can use multicast to reduce network traffic.
Advertise Routes: Enable or disable the Switch to advertise its own routing table.
Advertise Default Route: Enable or disable the Switch to advertise its own default route.
Accept RIP V1/V2 Updates: Configure the Switch to accept routing table from other routers.
Enabling RIP-1 can only accept RIP-1 update but enabling RIP-2 can accept RIP-1, RIP-2 or
RIP-1/RIP-2 updates.
Use Split Horizon: This allows the Switch to never propagate routes back to an interface port
from which they have been acquired.
Use Poisoned Reverse: This allows the Switch to propagate routes back to an interface port
from which they have been acquired, but set the distance vector metrics to infinity.
Send Trigger Responses: If this configuration is Yes, whenever a route gets changed, the
Switch broadcast an update message after waiting for a short random delay, but without
waiting for the periodic cycle.
F IGURE 5-46
2. Review the settings. To change a setting, highlight it, press the Enter key, select the desired setting,
and press Esc.
3. To delete a setting, highlight the setting and press the - (hyphen) key. When a message asks you
to confirm the deletion, highlight Yes and press Enter to delete it, or press Esc or highlight No and
press Enter to retain it.
4. When you finish, press the Esc key until you return to the desired screen.