Pioneer Max 40XCAV ATAPI CD-ROM Drive Unit DR-944 - Manual (Page 3)

OB-U0192
3
Name of Parts/Function/Setting
Front Panel
1 . Disc Tray
Tray loading-unloading is done by pressing the eject button.
Place the CD-ROM onto the tray with the label facing up.
Place a disc onto the inner lower groove on the tray in case an 8cm disc is used.
Press the eject button or push the front part of the tray gently to load disc tray.
2 . Head-Phone Jack (PHONES)
Stereo mini jack for head-phone.
Adjust “Volume Control Knob” minimum position before head-phone is connected.
The audio output of rear panel is active even when head-phone plug is inserted to this jack.
3 . Volume Control Knob (Head-Phone Level)
This is the volume control knob for adjusting sound level for head-phone.
When the knob is turned to the right, the head-phone volume goes up, and turned to the left, the
volume goes down.
4 . BUSY Indicator
It is lit when data on the disc is accessed.
5 . Eject Button
This button is used to load and unload the tray.
6 . Forced Ejection Hole
When a disc is stacked in the drive and the eject button does not work to open the tray, insert a stiff rod
into this hole and push gently so that the tray comes out. Unload the tray by hand then remove the disc.
Do not use the Forced Eject Hole except emergency case, use the eject button in normal operation.
Before executing this operation, turn off the power supply and wait more than 1 minute till disc rotation is
stopped.
Name of Parts/Function/Setting