Perlick SELF CONTAINED H50IMS-ADR - Manual (Page 25)

25
3) Inside the storage bin, disconnect the suction tube by squeezing the tabs and pulling
the tube clear. See Fig. 26. Allow the water tank to drain.
4) Reconnect the suction tube as illustrated. See Fig. 27. Make sure the tabs lock into
place; a loose fitting may cause a water leak.
5) Slowly pour the cleaning solution into the water tank.
6) Move the control switch to the "WASH" position.
7) Allow the cleaning solution to circulate for 30 minutes, then move the control switch to
the "OFF" position.
8) Disconnect the suction tube. Allow the water tank to drain, then reconnect the suction
tube.
9) Move the control switch to the "ICE" position and allow the icemaker to operate for
2 minutes. This allows the water tank to fill with water.
10) Move the control switch to the "WASH" position.
11) Allow the water to circulate for 5 minutes, then move the control switch to the "OFF"
position.
12) Disconnect the suction tube. Allow the water tank to drain, then reconnect the suction
tube.
13) Repeat steps 9 through 12 three more times to rinse thoroughly.
Water Tank
Drain
Suction Tube
Tabs
Fig. 26 Fig. 27
Suction Tube
Tabs