Perlick SELF CONTAINED H50IMS-ADR - Manual (Page 10)

10
II. Installation and Operating Instructions
WARNING
1. This icemaker must be installed in accordance with applicable national,
state, and local regulations.
2. CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews
are securely in place after installation. Make sure that none have fallen into
the storage bin.
A. Checks Before Installation
• Visually inspect the exterior of the shipping container and immediately report any
damage to the carrier. Upon opening the container, any concealed damage should also
be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the icemaker,
it will not work properly.
• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the icemaker is exposed to the
sun or to heat, remove the film after the icemaker cools.
• See the nameplate inside the bin on the right side, and check that your voltage
supplied corresponds with the voltage specified on the nameplate.
B. Location
1. General
This icemaker is approved for indoor or outdoor use.
CAUTION
1. Normal operating ambient temperature should be within 45°F to 100°F (7°C
to 38°C); Normal operating water temperature should be within 45°F to 95°F
(7°C to 35°C). Operation of the icemaker, for extended periods, outside of
these normal temperature ranges may affect icemaker performance.
2. This icemaker will not work at sub-freezing temperatures. To prevent
damage to the water supply line, drain the icemaker if the air temperature is
going to go below 32°F (0°C). See "III.C. Preparing the Icemaker for Long
Storage."
For best operating results:
• The icemaker should not be located next to ovens, grills, or other high heat producing
equipment.
• The location should provide a firm foundation for the icemaker.
• This icemaker requires no side or top clearance. But allow enough space at rear for
water supply and drain connections and at least 15" (38 cm) clearance at front.