Perlick SELF CONTAINED H50IMS-ADR - Manual (Page 29)

29
B. Maintenance
IMPORTANT
This icemaker must be maintained individually, referring to the instruction
manual and labels provided with the icemaker.
1. Stainless Steel Exterior
To prevent corrosion, wipe the exterior occasionally with a clean and soft cloth. Use a
damp cloth containing a neutral cleaner to wipe off oil or dirt build up.
2. Storage Bin and Scoop
• Wash your hands before removing ice. Use the plastic scoop provided.
• The storage bin is for ice use only. Do not store anything else in the storage bin.
• Clean the scoop and the storage bin liner using a neutral cleaner. Rinse thoroughly
after cleaning.
3. Condenser
Check the condenser once a year, and clean if required by following the steps below.
More frequent cleaning may be required depending on location.
WARNING
1. Move the control switch to the "OFF" position and unplug the unit from the
electrical outlet before cleaning the condenser.
2. Condenser fins are sharp. Use care when cleaning.
1) Move the control switch to the "OFF" position and unplug the unit from the electrical
outlet.
2) Remove the 2 screws securing the front panel, then
remove the panel. See Fig. 40.
3) Remove the 2 screws securing the louver, then
remove the louver.
4) Use a brush attachment on a vacuum cleaner to
gently clean the condenser fins. Do not use too
much force, otherwise the fins could be damaged.
5) Replace the louver and front panel in their correct
positions. Ensure that the screws are securely in
place.
6) Plug the unit back in. Move the control switch to the "ICE" position to start the automatic
icemaking process.
Front Panel
Louver
Fig. 40
Screws
Screws
Condenser