Pioneer HTZ-FS30DVD - Manual (Page 18)

Getting started 04
18
En
1 Connect the microphone to the MCACC
MIC jack on the front panel.
2 Place the microphone at your normal
listening position.
Place it about ear height, and make sure it is
level by using a table or chair.
Make sure there are no obstacles between the
speakers and the microphone.
3 If the system is off, press
 STANDBY/ON to turn the power on.
When the speaker layout menu appears, see
Setting Speaker Layout on page 17 and select a
proper setting.
4 Press SHIFT+MCACC.
Try to be as quiet as possible after pressing
SHIFT+MCACC. The volume increases
automatically and the system outputs a series
of test tones.
• Press SHIFT+MCACC to cancel and revert
to the previous Auto MCACC settings.
• If the noise level is too high, NOISY blinks
in the display for five seconds. To exit and
check the noise levels
1
, press
SHIFT+MCACC, or to try again, press
ENTER when RETRY shows in the display.
• If you see an ERR MIC or ERR SP message
in the display, there may be a problem with
your mic or the speaker connections. To try
again, press
ENTER when you see RETRY. 2
When MCACC setup is complete, the volume
level returns to normal and
COMPLETE 3
shows
in the display, indicating that the MCACC
setup is complete and Acoustic Calibration EQ
has been activated.
4
• Be sure to disconnect the microphone
from this unit upon completion of the Auto
MCACC setup.
Using the on-screen displays
For ease of use, this system makes extensive
use of graphical on-screen displays (OSDs).
All the screens are navigated in basically the
same way, using
, , ,  to change the
highlighted item and pressing ENTER to select
it. 5
Important
• Throughout this manual, ‘Select’ means
use the cursor buttons to highlight an item
on-screen, then press
ENTER.
Note
1 • If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles
blocking the speakers from the microphone) the final settings may be incorrect. Check for household appliances (air conditioner,
fridge, fan, etc.), that may be affecting the environment and switch them off if necessary.
• Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV during the Auto
MCACC setup.
USB PHONES MAIN SUB
MCACC SET UP
MIC
MAIN SUB
MCACC SET UP
MIC
2 If this doesn’t work, press SHIFT+MCACC, turn off the power, and check the problem indicated by the error message, then try
the Auto MCACC setup again.
3 If
COMPLETE doesn’t appear, it is likely an error occurred during the setup. Please check all connections and try again.
4 See Listening with Acoustic Calibration EQ on page 24 to switch on/off Acoustic Calibration EQ.
5 The screen saver will appear after five minutes of inactivity.
Button What it does
HOME
MENU Displays/exits the on-screen display
 Changes the highlighted menu item
ENTER Selects the highlighted menu item
RETURN Returns to the main menu without
saving changes
HTZ585DVD_EN.book 18 ページ ２００９年３月１９日 木曜日 午後６時３５分