Pioneer HTZ-FS30DVD - Manual (Page 46)

Other connections 12
46
En
Connecting Optional Bluetooth
ADAPTER
1 Switch the system into standby and
connect Bluetooth ADAPTER to the ADAPTER
PORT located in the rear panel.
For the connection diagram, see 7 on page 42.
2 Press  STANDBY/ON.
3 Press ADAPTER PORT and to switch to BT
AUDIO input mode.
1
Pairing Bluetooth ADAPTER and
Bluetooth wireless technology
device
“Pairing” must be done before you start
playback of Bluetooth wireless technology
content using Bluetooth ADAPTER. Make sure
to perform pairing first time you operate the
system or any time pairing data is cleared.
“Pairing” is the step necessary to register
Bluetooth wireless technology device to enable
Bluetooth communications.
2 For more details,
see also the operating instructions of your
Bluetooth wireless technology device.
1 Press SHIFT+SETUP to select BT SETUP,
then press ENTER.
2 Use
/ to select PAIRING, then press
ENTER.
3 Select the PIN code to be used from 0000/
1234/8888 using /, then press ENTER.
PAIRING blinks.
CAUTION
• You can use any of 0000/1234/8888 PIN
codes. Bluetooth wireless technology
device using any other PIN code cannot be
used with this system.
4 Switch on the Bluetooth wireless
technology device that you want to make
pairing, place it near the system and set it
into the pairing mode.
5 Check to see that the Bluetooth ADAPTER
is detected by the Bluetooth wireless
technology device.
When the Bluetooth wireless technology
device detects the Bluetooth ADAPTER, the
adapter’s identification “AS-BT100” appears in
the Bluetooth wireless technology device list. 3
6 From the Bluetooth wireless technology
device list, select Bluetooth ADAPTER and
enter the PIN code selected in the step 3.
4
Listening to Music Contents of
Bluetooth wireless technology
device with Your System
1 Press ADAPTER PORT and to switch to BT
AUDIO input mode.
2 Connect the Bluetooth wireless
technology device to the Bluetooth
ADAPTER.
Note
1 When the Bluetooth ADAPTER is not plugged in the ADAPTER PORT, BT AUDIO input mode cannot be entered even if
ADAPTER PORT is pressed.
2 • Pairing is required when you first use Bluetooth wireless technology device and Bluetooth ADAPTER.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology
device.
3 When a Bluetooth wireless technology device does not appear in the list of detected devices or has no display, the Bluetooth
wireless technology device list does not appear. In some cases, you may pair the Bluetooth ADAPTER and that Bluetooth wireless
technology device by using the pairing mode.
4 PIN code may in some case be referred to as PASSKEY.
HTZ585DVD_EN.book 46 ページ ２００９年３月１９日 木曜日 午後６時３５分