Pioneer Super Tuner III D AVH-P6850DVD - Manual (Page 80)

Black plate (80,1)
FRONT-L (front speaker left) —CENTER (center
speaker)
—FRONT-R (front speaker right)—
REAR-R (rear speaker right) —REAR-L (rear
speaker left)
—SUB WOOFER (subwoofer)
# You cannot select speakers whose size is set
to
OFF at the SPEAKER SETTING menu.
3 Touch c or d to adjust the speaker out-
put level.
Each time you touch c or d increases or de-
creases the speaker output level.
+10 to
–10 is
displayed as the level is increased or de-
creased.
Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
TEST TONE. Both provide the same results.
Selecting a cross-over
frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to
SMALL, you can select a
frequency, under which sounds are repro-
duced through a
LARGE speaker or subwoo-
fer.
1 Touch CROSS OVER on the DSP function
menu.
2 Touch c or d to select the speaker to
be adjusted.
Each time you touch c or d selects the speak-
er in the following order:
FRONT (front speakers)
—CENTER (center
speaker) —REAR (rear speakers)—
SUB WOOFER (subwoofer)
3 Touch c or d to select cross-over fre-
quency.
Each time you touch c or d selects cut-off fre-
quencies in the following order:
63
—80—100—125—160—200 (Hz)
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofer
’s L.P.F. (low-pass
filter) and that of the SMALL speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to
OFF and other
speakers are set to LARGE or OFF.
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1 Touch TEST TONE on the DSP function
menu.
2 Touch START to start the test tone out-
put.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
FRONT-L (front speaker left)
—CENTER (center
speaker)
—FRONT-R (front speaker right)—
REAR-R (rear speaker right) —REAR-L (rear
speaker left)
—SUB WOOFER (subwoofer)
Check each speaker output level. If no adjust-
ments are needed, perform step 5 to stop the
test tone.
# The settings do not appear for speakers
whose size is set
OFF.
<CRB2163-B>80
Digital Signal Processor
En
80
Section
17