Pioneer DRM-1004 - Manual (Page 11)

11
<DRC1129>
En
NOTE:
÷ While discs are loaded in the
magazine, do not turn it upside
down. Otherwise the discs will drop.
4. Insert discs in the magazines.
÷ Set discs with the label sides facing up taking care so that no disc
is inserted obliquely.
÷ Each magazine accommodates a total of 50 discs.
÷ Never insert a disc obliquely, otherwise it will be damaged.
HOW TO INSTALL OR EXCHANGING DISCS
5. Press the MAIL SLOT OPEN/CLOSE button.
÷ The MAIL SLOT closes.
÷ The indicator which indicates the presence of a disc in the mail slot
lights up, and the disc is transported to the disc address specified
above.
÷ When the disc is inserted in the disc address, it is stored in
memory. Now the installation of that disc is complete.
6. Install 100 discs by repeating the above steps.
)
OPEN/CLOSE
) OPEN/CLOSE
T T
T TT
DOOR OPEN
0
1 2 3
4 5 6
7 8 9
LOOK
UNLOOK
POWER
MAIL SLOT
DRIVE 4 DRIVE 3 DRIVE 2 DRIVE 1
ESC ENT
Method of inserting discs by taking out the
50-disc magazines
With this method, the magazines are designed so that they cannot be
taken out without using the key in order to protect discs from theft.
1. Insert the key into the Key switch and turn it to
the UNLOCK position.
÷ The DOOR OPEN button lights up.
2. Press and hold the DOOR OPEN button for more
than 4 sec.
÷ The blinking “OP” appears on the mode indicator and the
mechanism is initialized in this period.
÷ After initialization, the front door opens.
÷ “OPU-L” is displayed. “U” indicates the upper magazine and “L”
indicates the lower magazine.
) OPEN/CLOSE
T T
T TT
DOOR OPEN
0
1 2 3
4 5 6
7 8 9
LOOK
UNLOOK
POWER
MAIL SLOT
DRIVE 4 DRIVE 3 DRIVE 2 DRIVE 1
ESC ENT
LOCK
UNLOCK
) OPEN/CLOSE
T T
T TT
DOOR OPEN
0
1 2 3
4 5 6
7 8 9
LOOK
UNLOOK
POWER
100 DISCS CD -- ROM AUTCHANGER
MAIL SLOT
DRIVE 4 DRIVE 3 DRIVE 2 DRIVE 1
ESC ENT
DOOR OPEN \
3. Stand the magazine handle toward the front and,
while pushing the eject button, pull out the maga-
zine toward the front.
÷ The indicator which indicates that a magazine is pulled out blinks.
Both of the two magazines can be taken out.
\
\
When loading the magazine with discs directly by hand, take
care of the following points.
÷ Insert each disc with the label side up.
÷ Insert each disc horizontally by aligning it with the shelves on the
left and right. Do not insert obliquely to prevent damaging the disc.
÷ Do not leave fingerprints on the recording surface of disc.
To insert discs securely into the magazine, it is recommended
to load discs using the mail slots whenever possible.
5. Load the magazines back in the Changer.
÷ Fold the handle toward the left as you push the silver plate.
Label surface
Eject button