Pioneer DRM-1004 - Manual (Page 4)

4
<DRC1129>
En
LINE VOLTAGE SELECTOR SWITCH
The line voltage selector switch is located on the rear panel of this
changer. Check that it is set properly before plugging the power
cord into the outlet. If the voltage is not properly set or if you move
to an area where the voltage requirements differ, adjust the
selector switch as follows:
÷ Be sure to disconnect the power cord from its outlet before
making this adjustment.
÷ Use a medium-size (flat blade) screwdriver. Insert the tip of the
screwdriver into the groove of the selector switch and turn it
so that the arrow points to the power voltage making of your
area.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging
the cord and never touch the power cord when your hands are wet
as this could cause a short circuit or an electric shock. Do not place
the unit, a piece of furniture, etc., on the power cord, or pinch the cord.
Never make a knot in the cord or tie it with other cords. The power
cords should be routed such that they are not likely to be stepped on.
A damaged power cord can cause a fire or give you an electrical shock.
Check the power cord once in a while. When you find it damaged, ask
your nearest PIONEER authorized service center or your dealer for a
replacement.
Thank you for buying this Pioneer product.
Please read through these operating instructions so you
will know how to operate your model properly. After you
have finished reading the instructions, put them away in a
safe place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown in
the explanatory drawings. However, the method of
connecting and operating the unit is the same.
÷ Capacity for 100 discs
Two 50 disc magazines that can be replaced from
the front.
÷ Disc replacement time (clamp up to next disk
clamp) is an average of 5 seconds (maximum of 7
seconds).
÷ Comes with a mail slot (horizontal tray type)
Can be used for disk replacement and plus one
disc.
÷ Equipped with a control panel.
Can be used for off-line disc replacement.
÷ Uses an SCSI2 interface
÷ Equipped with a SCSI bus terminal
÷ Up to four optional drives can be installed.
Each drive has an external SCSI terminal so that it
can handle multi-purpose system integration.
The ID of the drive is automatically confirmed by the
changer.
100V
120V
230V
FEATURES ................................................................................. 4
HANDLING PRECAUTIONS ...................................................... 5
HOW TO LOCK THE CASTERS ................................................. 6
CHECKING THE ACCESSORIES ............................................... 6
PANEL FACILITIES .................................................................... 7
OPTIONAL DRIVE AND INSTALLATION ................................... 8
CONNECTIONS ......................................................................... 9
HOW TO INSTALL OR EXCHANGING DISCS ......................... 10
FUNCTION SWITCH DESCRIPTION ....................................... 13
TROUBLESHOOTING .............................................................. 14
SPECIFICATIONS .................................................................... 15
CONTENTS
FEATURES