Panasonic SC-PM47 - Manual (Page 19)

RQT6530
19
Listening operations
1
2
3
TAPE
VOLUME
DOWN UP
B
OPEN
2
3
1
/ / REW/ , / FF
OPEN
c
DEMO
Cassette tapes
1
Press [ c OPEN], insert a cassette with the
tape facing in.
When the button is pressed, the unit comes on
automatically.
Make sure the cassette is fully inserted and close the
lid by hand.
2
Press [ 3 TAPE ] to start playback.
3
Adjust the volume.
To stop tape playback
Press [
L /–DEMO].
One-touch play
When the system is OFF and a cassette is already inserted,
play starts automatically when you press [
3 TAPE].
Fast-forward and rewind
Press [
4 4 4 4 4 /REW/ g ] (rewind) or [ 3 3 3 3 3 /FF/ f ] (fast-forward)
in the stop mode.
Cassette tape selection and care
Types of tapes which can be played correctly.
The system automatically identifies the type of tape.
NORMAL POSITION/TYPE I ✓
HIGH POSITION/TYPE II ✕
METAL POSITION/TYPE IV ✕
High position and metal position tapes can be played, but
the unit will not be able to do full justice to the characteristics
of these tapes.
• Tapes exceeding 100 minutes are thin and can break or
get caught in the mechanism.
• Tape slack can get caught up in the mechanism and
should be wound up before the tape is played.
• Endless tapes can get caught up in the deck’s moving
parts if used incorrectly. Always read the instructions
provided with your tapes.
To find the beginning of a program
(TPS: Tape Program Sensor)
TPS finds the beginning of a track and resumes play from
there. Each press increases the number of tracks skipped,
up to a maximum of 9.
Press [ 4 4 4 4 4 /REW/
g
] or [ 3 3 3 3 3 /FF/
f
] during play.
Notes
The TPS function searches for silent parts of about 4
seconds in length which are normally found between tunes.
As a result, it may not function properly in the following
cases:
• With short silent parts
• When noise occurs between tunes
• With silent parts found within tunes
Forward side
Insert inside the
guides
RQT6530(16-22).p65 5/9/2002, 6:41 PM 19