Panasonic PT-DW90XE - Manual (Page 38)

Removing/attaching the projection lens (optional)
38
- ENGLISH
Getting Started
Removing/attaching the projection lens (optional)
Move the lens to the home position before replacing or removing the projection lens. ( Æ page 44)
How to install the projection
lens
Align the mark (orange) on the 1 )
projection lens with the mark on
the projector ( on the left side of
LOCK), then insert the lens and turn it
clockwise until there is a click.
Ensure that the mark on the projection lens is z
aligned with the tip of the mark (arrow) on the
projector.
Fix the projection lens with the 2 )
attached “Lens fixing screw”. Û
Tighten the screw into the first screw hole z
on the right side of the mark (orange) of the
projection lens with a Phillips-head screwdriver.
(There is not the projection lens fixing tap hole
on all the lenses.)
How to remove the projection
lens
Remove the “Lens fixing screw”. 1 ) Û
Remove the first screw on the right side of the z
mark (orange) of the projection lens with a
Phillips-head screwdriver.
While holding down the “LOCK 2 )
button”, turn the projection lens
counterclockwise, and then pull it off.
Turn the projection lens counterclockwise until z
its mark (orange) is aligned with the mark on
the projector ( on the left side of LOCK).
Some types of the lens do not have the projection lens fixing screw hole. : Û
Attention
Do not touch the lens signal receiver. Dust or dirt may cause defective contact. z
Do not touch the surface of the projection lens with your bare hands. z
Store the replaced lens where it will be free from vibration and impact. z
Turn the projection lens counter clockwise to confirm that it does not come out. z
LOCK button