Planet Technology 802.11n Wireless ADSL 2/2+ Router ADN-4000 - Manual (Page 7)


3. Connect ADSL Cable
Connect the supplied ADSL cable from to the WAN port on the ADN-
4000 (the RJ-11 connector) to the ADSL terminator provided by your
phone company.
4. Power Up
Connect the supplied power adapter to the ADN-4000. Use only the
power adapter provided. Using a different one may cause hardware
damage.
5. Check the LEDs
• The PWR LED should be ON.
• The WLAN LED should be flash, when wireless AP is ready.
• The ADSL LED should be ON if ADSL line is connected.
• For each LAN (PC) connection, one of the LAN LEDs should be ON
(provided the PC is also ON.)