Panasonic TQBJ0323-1 - Manual (Page 23)

Basic operations
ENGLISH  23
Turn the projector ON or OFF (continued)
TURN THE PROJECTOR OFF
STANDBY TT
(R)
ON(G)
AUTO
SETUP
MENU RETURN
ENTER
FREEZE
AV AA
MUTE
1) 2)
When operating the projector, check the status of the POWER indicator. ( page 21)
1 Press the POWER button.
A confirmation screen will be displayed – the
screen will go off and return to projection if there
is no operation for approximately 10 seconds.
2 Press the button again.
The lamp goes off and the projection stops.
The cooling fan continues its rotation and •
POWER indicator lights orange. Wait until the
POWER indicator turns red.
If • STANDBY MODE is set to NORMAL, the
POWER indicator flashes red. ( page 39)
3 Disconnect the power plug from the wall
outlet after the POWER indicator turns red.
( page 21)
For urgency, you may disconnect the power •
plug immediately since the DIRECT POWER
OFF function is installed.
NOTE:
Confirm that • CONTROL PANEL (when operating with
the projector body) or REMOTE CONTROLLER (when
operating with the remote control) under CONTROL
DEVICE SETUP in the SECURITY menu is set to ENABLE.
(  page 44)
Power can be turned off by pressing • [POWER] for
at least 0.5 seconds.
POWER indicator