Panasonic TQBJ0323-1 - Manual (Page 49)

Maintenance
ENGLISH  49
Care and Replacement (continued)
9
ENTER
To select the
PROJECTOR SETUP
menu.
To select LAMP
RUNTIME.
10
ENTER
Press and hold for
approximately
3 seconds.
LAMP RUNTIME
LAMP RUNTIME RESET.
OK
CANCEL PRESS ANY OTHER BUTTON PRESS BUTTON
NOTE:
If any button other than the • [POWER] is pressed, the
LAMP RUNTIME screen disappears and the lamp
runtime is not reset. (Repeat from step 8 again).
11 After the lamp goes off,
projection stops and the
[POWER] button on the main
unit lit red. Disconnect the power
plug.
The lamp runtime has been
reset to “0”.
Ceiling mount bracket safeguards
Installation work of the ceiling mount bracket should only be carried by a qualified technician. •
Even if it is during guaranteed period, the manufacturer is not responsible for any hazard or damage caused •
by using a ceiling mount bracket which is not purchased from an authorized distributors, or environmental
conditions.
Remove an unused ceiling mount bracket promptly. •
Ensure to use a torque driver and do not use an electrical screwdriver or an impact screwdriver. •
For details, see the work instruction manual packed together with the ceiling mount bracket. •
The model Nos. of the accessories and the parts sold separately are subject to change without notice. •
M4 × 0.7
Torque:1.25 ± 0.2 N.m
Model No. of ceiling mount bracket: ET-PKB2
9 mm