Pinnacle Speakers Lightning 1000 - Manual (Page 32)

26
Lightning 1000 Installation Guide
Reference Connection
To connect video reference:
1. Connect a stable analog reference signal (such as Black Burst)
from your house sync generator to the left-hand Reference
connector.
Note
The house sync generator must feed the same reference to all devices in
your Lightning system.
2. If Lightning is the last device in your reference loop, terminate the
right-hand Reference connector with a 75-ohm terminator as
shown below.
Reference Out
Loop
Loop
75 Ohm
Terminator
Sync Generator
VTR 1
VTR 2
Lightning
3. If Lightning is in the middle of your reference loop, connect the right-
hand Reference connector to the next device’s reference input connector, as
shown below
VTR 2
Lightning
Reference Out
Loop
Loop
Loop
to next
device
Sync Generator
VTR 1