Powercom 625A - Manual (Page 8)

4. Installation
__________________________________________________________
____
4.0 Inspection
Inspect the UPS upon receipt. The packaging is recyclable; save it for reuse or
dispose of it properly.
4.1 Placement
Install the UPS in a protected area with adequate air flow and free of excessive
dust. Do not operate the UPS where the temperature and humidity is outside
the specified limits.
4.2 Connect Computer Interface (425AP/525AP/625AP models only)
UPSMON (or other power management software) and an interface kits can be
used with this UPS. Use only kits supplied or approved by the manufacturer.
If used, connect the interface cable to the 9 pin computer interface port on the
back panel of the UPS.
Note: Computer interface connection is optional. The UPS works
properly without a computer interface connection.
4.3 Connect to Utility
Connect the AC input power connector to utility power to power up the UPS.
4.4 Charge the battery
The UPS charges its battery whenever it is connected to utility power. For best
results, charge the battery for 4 hours in the initial use.