NEC MM2000 - Manual (Page 24)

16
3.
Projecting an Image
Specify “Title select” from the projector to project images of a device connected to this unit. Refer to the Projector User’s
Manual for details on how to operate the projector.
The procedures to turn on and off this unit are described below.
3-1. Turning on the Switcher
NOTE • When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed
to the off[O] position. Failure to do so may cause damage to the Switcher.
• The Switcher has two power switches: main power switch and POWER button.
Turn on the power switch of the projector connected to the
Switcher.
To turn on the main power to the Switcher, press the Main
Power switch to the ON position ( I ).
POWER POWER
ON/STAND BY
Standby Power ON
Steady orange
light Steady green
light
Before you turn on your Switcher, ensure that the computer or
video source is turned on.
Only after you press the ON/STAND BY button on the Switcher
cabinet for a minimum of 1 second will the power indicator
turn to green and the Switcher become ready to use.