Appendix b: connector pin assignments – NETGEAR FS518T User Manual
Page 34
connector pin assignments B-1
APPENDIX B: CONNECTOR PIN ASSIGNMENTS
This appendix provides information about the RJ-45 plug and the RJ-45 connector
used for the NETGEAR Model FS518T Fast Ethernet Switch with Gigabit uplinks.
RJ-45 Plug and Vista RJ-45 Connector
In a Fast Ethernet network, it is important that all 100BASE-T certified Category 5
cabling use RJ-45 plugs. The RJ-45 plug accepts 4-pair UTP or shielded twisted
pair (STP) 100 ohm cable and connects into the vista RJ-45 connector.
The vista RJ-45 connector is used to connect stations, hubs, and switches through
UTP cable; it supports 10 Mbps, 100 Mbps, or 1000 Mbps data transmission.
The RJ-45 plug and vista RJ-45 connector are both illustrated in Figure B-1.
Key:
1 to 8 = pin numbers
Figure B-1. RJ-45 Plug and Vista RJ-45 Connector with Built-in LEDs
711EA
1
8
12345678
FS518T.Manual.FINAL 5/19/00 12:55 PM Page 37