NETGEAR Cable/DSL ProSafe Firewall FR328S User Manual
Page 73
FR328S ProSafe Firewall with Dial Back-Up Reference Manual v2
Managing Your Network
6-11
M-10207-01, Reference Manual v2
2.
The firewall will then reboot automatically.
After an erase, the firewall password will be password, the LAN IP address will be
192.168.0.1, and the router's DHCP client will be enabled.
Note: To restore the factory default configuration settings without knowing the login
password or IP address, you must use the Default Reset button on the rear panel of the
firewall. See
“Using the Default Reset button“ on page 8-7
Running Diagnostic Utilities and Rebooting the Router
The FR328S Firewall has a diagnostics feature. You can use the diagnostics menu to perform the
following functions from the firewall:
•
Ping an IP Address to test connectivity to see if you can reach a remote host.
•
Perform a DNS Lookup to test if an Internet name resolves to an IP address to verify that the
DNS server configuration is working.
•
Display the Routing Table to identify what other routers the router is communicating with.
•
Reboot the Router to enable new network configurations to take effect or to clear problems
with the router’s network connection.
From the Main Menu of the browser interface, under the Maintenance heading, select the Router
Diagnostics heading to display the menu shown in
.
Figure 6-9: Diagnostics menu