Nexgrill 720-0140-LP - Manual (Page 29)

GRILL LIGHTING INSTRUCTIONS
FLAME CHARACTERISTICS
Check for proper burner flame characteristics.
Each burner is adjusted prior to shipment;
however, variations in the local gas supply
may take minor adjustments necessary.
Burner flames should be blue and stable with
no yellow tips, excessive noise, or lifting. If
any of these conditions exist call our customer
service line. If the flame is yellow, it indicates
insufficient air. If the flame is noisy and tends
to lift away from the burner, it indicates too
much air.
TO MATCH LIGHT THE GRILL
If the burner will not light after several
attempts then the burner can be match lit.
Lighting rod-Here is your instruction:
Match light extension rod
Use this device to match light your burners
Simply place a lighted match between the coils on
the end of the extension rod and hold next to the
burner to ignite. (see reference Pg)
If you’ve just attempted to light the burner with
the igniter, allow 5 minutes for any
accumulated gas to dissipate. Keep your face
and hands as far away from the grill as possible.
Insert a lit match attached to tight lighting rod
or lighter through the cooking
grids to the burner.(see next page) Press the
control knob and rotate left to the HI setting,
continue to press the knob until the burner
ignites. Burner should light immediately. If the
burner does not light in 4 seconds turn the knob
off, wait 5 minutes and try again.
Keep a spray bottle of soapy water near the
gas supply valve and check the connections
before each use.
Do not attempt to light the grill if odor of gas
is present. Call for service 1-800-790-1299.
USING SIDE BURNER
WARNING: Always keep your face and body
as far away from the burner as possible when
lighting.
LIGHTING INSTRUCTIONS
To light the side burner, remove any cooking
utensils from the burner grate. Push and turn
the control knob counterclockwise to the “HI”
position. If the burner does not light, turn the
WARNING: IMPORTANT!
USING THE SIDE BURNER:
Inspect the gas supply hose prior to turning
the gas “ON”. If there is evidence of cuts,
wear or abrasion, it must be replaced prior to
use. Do not use the side burner if the odor of
gas is present.
27