NETGEAR MBR624GU - Manual (Page 16)

3G Broadband Wireless Router MBR624GU User Manual
1-2 Installing Your Router
v1.0, January 2009
Front Panel
The router front panel shown below contains status LEDs.
You can use the LEDs to verify various conditions. The following table describes each LED..
Figure 1-1
Table 1. LED Descriptions
LED Activity Description
1. Power,
factory
reset
Solid green
Solid red
Off
Factory reset Power is supplied to the router.
POST (Power-On Self-Test) failure or device malfunction.
Power is not supplied to the router.
During a reset, lights momentarily, blinks red three times, and then
turns green as the gateway resets to the factory defaults.
2. Ethernet
ports 1-4
Solid green
Blinking green
Solid Amber
Blinking amber
Off
The powered device is connected to the associated Ethernet Local
Area Network (LAN) port, which is operating at 100 Mbps.
Data is being transmitted or received at 100 Mbps.
The powered device is connected to the associated Ethernet Local
Area Network (LAN) port, which is operating at 10 Mbps.
Data is being transmitted or received at 10 Mbps.
No link is detected on this port, or no cable or no powered device is
connected to the associated port.
3. Wireless
Solid green
Blinking green
Off The wireless access point is enabled.
Data is being transmitted or received over the wireless link.
The wireless access point is disabled.
1 2 3 4
5