Nautique SPORT NAUTIQUE 216 - Manual (Page 112)

4-43
Automatic Bilge Panel
Bilge Pump Only Mode - This feature is activated by a switch located
on the side console. The switch has three positions, ON, OFF and
BILGE. If the boat is going to sit for more than a few days with the
bilge pumps on, it is important the switch is set in the BILGE
position to minimize battery drain. This will activate the bilge pump
and shut off power to the Serial Switching and Keyless Ignition
System. It is important to remember the engine or other accessories
can not be used unless the switch is in the ON position.
A circuit breaker and indicator light is located with the switch for
the bilge pump. The circuit breaker is only active when the switch
is in the BILGE position. The indicator light will come on anytime
the bilge pump is activated.
Bilge Pump On
All Off
All On
Bilge
Bilge
Pump
Pump
Circuit
Breaker
Indicator
CORC024
WATER
E E 1/2 1/2 F F
WATER
CORC049
Controls and Indicators
Sport
Nautique Sport Sec 4.qxd 11/19/04 4:02 PM Page 43