Check for water in your fuel system – Nautique SPORT NAUTIQUE 216 User Manual

Page 169

Advertising
background image

Correct Craft, Inc.

10-4

Check For Water In Your Fuel
System

A small amount of water left in the fuel system for several months
can result in damage to the fuel system and engine. If you are
storing your boat for the winter, it is a good practice to remove any
water in the fuel system.

The Fuel Control Cell can be drained by removing the drain plug
at the bottom of the canister.

1. Loosen the incoming fuel hose to provide an incoming air

source.

2. Clamp the incoming fuel line some way to minimize the

amount of fuel that may drain.

3. Once the canister is drained, coat the threads of the drain plug

with a fuel resistant pipe thread sealer, then replace and tighten
the plug.

4. Reconnect the fuel hose, and tighten the hose clamp. The

threads must be sealed properly to avoid a possible fuel leak.

Check your Fuel Control Cell once each year for signs of water in
the canister. If it appears there is water buildup in the canister, see
your Correct Craft dealer for service.

An empty fuel tank can accumulate water inside by changing
temperature and repeated cycles of condensation on the inner
surfaces of the tank. If the fuel tank is kept at about 3/4 full during
storage, less water can condense, limiting the buildup of water in
the fuel tank.

Fill the tank to 3/4 full maximum during storage to eliminate the
possibility of fuel expansion caused by temperature changes. This
minimizes overflow of fuel from the fuel vent. Not only can this
overflow be hazardous, but it will also adversely affect decals and
pin striping on the boat.

Section 10

Nautique Sport Sec 10.qxd 11/19/04 3:24 PM Page 10-4

Advertising
This manual is related to the following products: