NEC LT158 - Manual (Page 22)

E – 18
NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the power to the notebook PC. In most cases
signal cannot be output from RGB output unless the notebook PC is turned on after connecting with the projector.
NOTE:
* If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver or power management software.
* If you accidentally hit the POWER button on the remote control, wait 60 seconds and then press the POWER button again to resume.
NOTE: If using video, S-video, or audio cables, the cables should be 3 m (9.8 feet) or shorter.
For LT158:
When Viewing a DVI Digital Signal:
To project a DVI digital signal, be sure to connect the PC and the projector using the supplied DVI-D signal cable before turning on your PC or
projector. Turn on the projector first and select DVI (DIGITAL) from the source menu before turning on your PC.
Failure to do so many not activate the digital output of the graphics card resulting in no picture being displayed. Should this happen, restart your PC.
Do not disconnect the supplied DVI-D signal cable while the projector is running. If the signal cable has been disconnected and then re-connected,
an image may not be correctly displayed. Should this happen, restart your PC.
NOTE: Some personal computers or video cards may not display images correctly on the LT158.
To connect a DVI connector on your computer to LT158, attach the supplied DVI-D – DVI-D signal cable to the DVI connector on the projector. If you use a separately
sold DVI cable, images may not be correctly displayed.
NOTE: The DVI connector can accept a maximum resolution of 1024x768(XGA) when a DVI (DIGITAL) input is selected.
PC CONTROL
VIDEO S-VIDEO RGB AUDIO
DVI
LT158
Wiring Diagram
RGB Signal cable (supplied)
To mini D-Sub 15-pin connector on
the projector. It is recommended that
you use a commercially available
distribution amplifier if connecting a
signal cable longer than the one
supplied.
For LT158:
DVI-D – DVI-D signal cable
(supplied) or DVI-A – VGA
signal cable (supplied)
To DVI connector on the projector.
IBM VGA or Compatibles
(Desktop type or notebook type)
DVD Player (with component output)
Component Video cable
RCA
ן3 (not supplied)
Document Camera
To video, S-video, and audio
inputs on the projector.
VCR, DVD Player or
LaserDisc Player
Macintosh or Compatibles
(Desktop type or notebook type)
Optional 15-pin-to-RCA
(female)
ן3 cable (ADP-CV1)
DVI-A – VGA signal
cable (supplied)
Gender changer
mini D-sub 15-pin F –
15-pin F (not supplied)