Operation, E – 24, On/ stand by – NEC LT158 User Manual
Page 28: Connect the supplied power cable to the projector, Turn on and off the projector, Power on button, Status of indicator light: turn on, Normal mode: stand by, Eco mode, Stand by
E – 24
3. OPERATION
Connecting the Power Cable and Turning on the
Projector
Before you turn on your projector, ensure that the computer or video
source is turned on and that your lens cap is removed.
1. Connect the supplied power cable to the projector.
ME
NU
EN
TE
R
CA
NC
EL
SE
LE
CT
PO
WE
R
ST
AT
US
ON
/
ST
AN
D B
Y
SO
UR
CE
AU
TO
AD
JU
ST
PC
C
AR
D
AC
CE
SS
AC
IN
C CARD
USB
PC CONTROL
VIDEO
S-VIDEO
RGB
AUDIO
Plug the supplied power cable in the wall outlet. The projector will
go into its standby mode and the power indicator will glow orange.
2. Turn on and off the Projector
MENU
OFF
VIDEO
AUTO ADJ.
S-VIDEO
RGB1
RGB2
LASER
ON
POWER
Power ON button
ME
N
E
NTER
CA
NC
EL
SELECT
POWER
STATUS
ON
/
STAND BY
SOURCE
AUTO
ADJUST
PC CARD
ACCESS
PC
C
ON
TR
OL VID
EO
S-V
ID
EO
Power ON/STAND BY button
Indicator
To turn on the projector:
Only after you press the “On” button on the remote control (“ON/
STAND BY” button on the projector cabinet) will the power indicator
turn to green and the projector become ready to use.
NOTE: To turn the projector on by plugging in the power cable, use the
menu and enable the “Auto Start” feature. (See page E-38.)
NOTE: Immediately after turning on the projector, screen flicker may occur.
This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.
To turn off the projector:
First press the “off” button on the remote control (“ON/STAND BY”
button on the projector cabinet) for a minimum of two seconds. The
power indicator will glow orange. After the projector turns off, the
cooling fans keep operating for one minute.
NOTE: Do not disconnect the power cable during this time. Then, unplug
the power cable. The power indicator will go out.
Status of indicator light: turn on
POWER
STATUS
POWER
STATUS
ON/
STAND BY
POWER
STATUS
Normal mode:
stand by
steady orange light
flashing green light
for one minute
steady green light
Eco mode:
POWER
STATUS
POWER
STATUS
POWER
STATUS
ON/
STAND BY
stand by
steady orange light
flashing green light
for one minute
(Normal mode)
steady green light
(Eco mode)
Status of indicator light: turn off
ON/
STAND BY
POWER
POWER
POWER
ON
steady green light
change to flashing
green light
steady orange light
cooling down
stand by
Press a minimum
of two seconds.