Nikon LT170 - Manual (Page 22)

E-22
Turning off the Projector
To turn off the projector:
First, press the POWER (ON/STAND BY) button on the projector cabinet
or the POWER OFF button on the remote control. The “Power Off / Are
you sure?” message will appear.
Secondly, press the ENTER button or press the POWER (ON/STAND
BY) or the POWER OFF button again.
The power indicator will glow orange. After the projector turns off, the
cooling fans keep operating for 60 seconds (Cooling-off time).
Lastly unplug the power cable. The power indicator will go out.
CAUTION
Do not unplug the power cable from the wall outlet under any one of
the following circumstances. Doing so can cause damage to the
projector:
• While the Hour Glass icon appears.
• While the cooling fans are running. (The cooling fans continue to
work for 60 seconds after the projector is turned off).
OFF
COMPUTER
AUTO ADJ.
P0WER ON
VIDEO
AUTO
MENU CANCEL
ASPECT
COMP. S-VIDEO
ENTER
LAMP
STATUS
POWER
ON/STAND BY
SELECT
MENU
SOURCE
ENTER
PROJECTING AN IMAGE (BASIC OPERATION)
After Use
Preparation: Make sure that the projector is not turned on.
1. Unplug the power cable.
2. Disconnect any other cables.
3. Retract adjustable tilt feet if extended.
ZOOM
FOCUS
LA MP ME NU
SOU RC E EN TE R
ST AT US PO WE R
ON /S TA ND BY
SE LE CT
CO MP UT E
S-V ID EO IN
AU DIO IN
VID EO IN
PU SH
CLOS E
3
1
2
ᕃ Lift the front part of the projector.
ᕄ Push and hold the PUSH symbol of the Adjustable Tilt Foot button to
extend the adjustable tilt feet up to a maximum height.
ᕅ Lower the front of the projector while pressing and holding the
Adjustable Tilt Foot button until retracting the Adjustable Tilt Foot
down to a minimum height.
4. Use the Lens Shutter lever to close the lens shutter.
ZOO M
FOC US
ME NU
SO URC E EN TER
SE LE CT
S-VIDEO IN
AUDIO IN
VI
PUS H
5. Put the projector and its accessories in the soft carrying case.
See “Using the Soft Carrying Case” on the following page.