NEC NP2250 - Manual (Page 140)


6. Using On-Screen Menu
[OPTIONS]
Setting Auto Adjust [AUTO ADJUST]
This feature sets the Auto Adjust mode so that the RGB image can be automatically or manually adjusted for noise
and stability. You can automatically make adjustment in two ways: [NORMAL] and [FINE].
OFF......................... The.RGB.image.will.not.be.automatically.adjusted.
You.can.manually.optimize.the.RGB.image.
NORMAL................. Default.setting..The.RGB.image.will.be.automatically.adjusted..Normally.select.this.option.
FINE........................ Select. this. option. if. fine. adjustment. is. needed.. It. takes. more. time. to. switch. to. the. source. than. when.
[NORMAL].is.selected.
Enabling Auto Power On [AUTO POWER ON (AC)]
Turns the projector on automatically when the power cable is inserted into an active power outlet and the main pow-
er switch is turned on. This eliminates the need to always use the POWER (ON/STANDBY) button on the remote
control or projector cabinet.
To use the AUTO POWER ON (AC) function, you must first press the main power switch to the position “On” before
plugging in the power cable.
Turning On the Projector By Applying RGB Signal [AUTO POWER ON(COMP/)]
When the projector is in standby condition, applying an RGB signal from a computer connected to the COMPUTER
1 IN or the COMPUTER 2 IN connector will power on the projector and simultaneously project the computer’s im-
age.
This functionality eliminates the need to always use the POWER button on the remote control or the projector cabi-
net to power on the projector.
To use this function, first connect a computer to the projector and the projector to an active AC input.
OFF......................... This.feature.is.disabled.
COMPUTER.1......... Applying.an.RGB.signal.from.a.computer.connected.to.the.COMPUTER.1.IN.input.will.power.on.the.pro-
jector.and.simultaneously.project.the.computer’s.image.
COMPUTER.2......... Applying.an.RGB.signal.from.a.computer.connected.to.the.COMPUTER.2.IN.input.will.power.on.the.pro-
jector.and.simultaneously.project.the.computer’s.image.
NOTE:
• Disconnecting an RGB signal from the computer will not power off the projector. We recommend using this function in combi-
nation of the AUTO POWER OFF function.
• This function will not be available under the following conditions:
- when a component signal is applied to the COMPUTER 1 or 2 IN connector
- when a Sync on Green RGB signal or composite sync signal is applied