Nikon WT-3 - Manual (Page 28)

20
3 Insert the battery as shown on the inside of the
battery chamber cover. The battery latch will slide
aside during insertion and pop up to lock the bat-
tery in place when fully inserted.
Inserting the Battery
To power the camera when the WT-3 is in place, insert the camera battery into the
WT-3 battery chamber. The WT-3 takes one EN-EL3e rechargeable Li-ion battery;
other batteries can not be used. Note that the drain on the battery is increased
when the WT-3 is attached.
The EH-6 AC Adapter
The optional EH-6 AC adapter can also be used to power the
camera when the WT-3 is connected. Connect the DC plug
on the AC adapter to the WT-3 DC-IN connector, not to the
camera.
2 Open the battery chamber cover.
4 Close the battery-chamber cover. Make sure the
cover is properly latched. The latch will click into
place when the cover is fully closed.
5 Turn the camera on and check the battery level in
the control panel or viewfi nder or using the Bat-
tery Info option in the camera setup menu.
1 Turn the camera off and rotate the control lock on
the WT-3 to the L position.
Removing the Battery
Being careful not to drop the battery, open the battery cham-
ber cover and remove the battery as shown at right.
Batery latch