Nikon WT-3 - Manual (Page 59)

51
Troubleshooting
Problem Solution
“POWER” LED does not light.
• Confi rm that battery is inserted in WT-3 and is fully
charged.
• Reattach WT-3.
• Insert memory card (transfer and print modes
only).
• Turn camera on.
• Press shutter-release button halfway to activate ex-
posure meters.
• Select On for Wireless transmitter > Wireless
LAN system option in camera setup menu.
• Open connection to printer (print mode only).
20
18
21, 30
—
—
34
31
All LEDs blink at once.
WT-3 hardware error. Contact a Nikon-authorized
service representative. 25, 29,
31
Wireless transmitter option
not available. • Reattach WT-3.
• Select PTP for USB option in camera setup menu. 18
11
Excessive radio interference. Change orientation of camera or antenna. 4
Camera displays “Ethernet ca-
ble is not connected.” Connect Ethernet cable or change interface setting
to Wireless & Ethernet. 4, 13,
49
Camera displays wireless error.
• Confi rm that host and wireless LAN adapter are on.
• Ensure that there are no obstacles between WT-3
and wireless LAN adapter.
• Check settings for host and / or wireless LAN adapter
and adjust camera settings appropriately.
—
—
14, 35
Camera displays TCP/IP or FTP
error.
• Check settings for host and / or wireless LAN adapter
and adjust camera settings appropriately.
• Check fi rewall settings.
14, 35
16, 48
Memory card error displayed. Confi rm that memory card is properly inserted. 21, 30
Photos can not be trans-
ferred to computer to which
PictureProject has been in-
stalled. • PictureProject version is incorrect. Update to latest
version or install version supplied with D200.
• Macintosh: If PictureProject was installed after WT-3
Setup Utility, reinstall WT-3 Setup Utility.
—
Transfer interrupted before all
photographs are sent.
Transfer will resume if camera is turned off and then
on again, exposure meters are reactivated, or On for
Wireless transmitter > Wireless LAN system.
34
Error displayed stating that no
images are available for print-
ing.
Only JPEG images can be printed from the camera.
Transfer RAW (NEF) images to computer and print
them from PictureProject or Nikon Capture version
4.4 or later.
—