Niles Audio HDL-4 - Manual (Page 11)

3. Make the connections to the HDL-4. The amplifier/speaker
connectors on the HDL-4 are removable. If you wish, you
may remove the HDL-4's connectors to facilitate installation
see (Figure 3). Strip 3/8" of insulation from the end of each
wire. Tightly twist the end of each wire until there are no
frayed ends. Insert each wire into the appropriate hole on the
spring-loaded connector terminals. Be certain that proper
phasing is observed—connect the positive terminals on the
HDL-4 to the positive terminals on the amplifier and speakers
and the negative terminals on the HDL-4 to the negative ter-
minals on the amplifier and speakers. Re-install the connec-
tors if they were removed. See (Figure 4).
4. Locate the pre-printed Room Labels. Affix the appropriate
label to the recessed area over each ON/OFF selector button.
10
H
I G H
D
E F I N I T I O N
S
P E A K E R
S
E L E C T I O N
S
Y S T E M
Figure 3
Removing the Connectors
Figure 4
Installing the Connectors