Niles Audio HDL-4 - Manual (Page 15)

14
H
I G H
D
E F I N I T I O N
S
P E A K E R
S
E L E C T I O N
S
Y S T E M
Balancing Speaker Volume
The volume control on your receiver or amplifier serves as the
"master" volume for all speaker pairs connected.
The volume level of the speakers may vary from room to room.
This is caused by several factors. Two lesser factors are the size
of the speaker and its efficiency. The largest factor is the physi-
cal size of the room.
The best way to balance speaker volume is to equip each of the
speaker pairs in your system with a Niles volume control. The
controls allow you to adjust the volume of each speaker pair
individually. If all the speaker pairs in your system are equipped
with Niles volume controls, you can leave the amplifier or
receiver volume set at one position and use the Niles controls
exclusively.
SPECIFICATIONS
Audio Power
Handling
250 watts/channel
continuous music
power
Frequency Response
+0 dB, -0 dB (flat) from
20 Hz to 20 kHz
Mounting
Table-Top component
Wiring Requirements
Individual runs of
2-conductor speaker
wire. Connectors
accommodate wire
sizes 14-22 gauge (16
gauge recommended)
Overall Dimensions
17" wide x 2" high x
8-3/4" deep
Weight
4 1/2 lb.