National Instruments NI WLS/ENET-9163 - Manual (Page 23)

© National Instruments Corporation 23 NI WLS/ENET-9163 Carrier User Guide and Specifications
Specifications
These specifications are typical at 25 °C unless otherwise noted.
For C Series I/O module specifications, refer to the documentation
included with the modules.
Note These specifications are for the NI WLS/ENET-9163 carrier only, unless otherwise
noted.
Analog Input
Input FIFO size ...................................... 4095 samples >16 bit
8191 samples
≤16 bit
Sample rate 1
NI WLS/ENET-9163 carrier........... 5 MS/s (multi-channel,
aggregate), maximum
With NI WLS/ENET-9215 ............. 100 kS/s, maximum
Timing accuracy 2 ................................... 50 ppm of sample rate
Timing resolution 2 ................................. 50 ns
Number of channels supported .............. Determined by the C Series
I/O module
Digital Triggers
Static Characteristics
Number of terminals .............................. 2 bi-directional, individually
settable
Pull-down resistor .................................. 49.9 k Ω ±0.5%
Input voltage protection 3 ........................ ±20 V on each pin
Power–on state ....................................... Input
Required minimum input pulse width.... 100 ns
1 Performance dependent on type of installed C Series I/O modules and number of channels in the task.
2 Does not include group delay. Refer to C Series I/O module documentation for more information.
3 Stresses beyond those listed under Input voltage protection may cause permanent damage to the device.