National Instruments NI WLS/ENET-9163 - Manual (Page 9)

© National Instruments Corporation 9 NI WLS/ENET-9163 Carrier User Guide and Specifications
Figure 3. Stacking Grooves and Rubber Standoffs for Desktop Use
Mounting the NI WLS/ENET-9000 Series Device
You can mount the NI WLS/ENET-9000 Series device using a 75 mm
DIN-Rail kit or a panel mount kit. For kit accessory ordering information,
refer to the accessory section of the NI WLS/ENET-9163 product page at
ni.com .
Caution Your installation must meet the following requirements:
• Allows 25.4 mm (1 in.) of clearance above and below the NI WLS/ENET-9000 Series
device for air circulation.
• Allows 50.8 mm (2 in.) of clearance in front of modules for common connector
cabling, such as the 10-terminal detachable screw terminal connector.
1 Stacking Grooves
(NI ENET-9000 Series Only) 2 Rubber Standoffs
1
2