NDC comm NWH650 - Manual (Page 16)

10 InstantWave High Rate 11Mbps Access Point
Hardware Pre-Configuration
Before adding an AP into an existing Ethernet network, you may need to set basic
configurations, e.g. domain name (SSID), security setting (WEP), AP name,
channel number, or IP address in order to make it compatible with the existing
network.
Follow the steps below to connect the AP to a PC for configuration:
step1. Connect the supplied RS-232 cable to the COM port on the AP and
connect the other end to a serial port (COM port) on the PC
step2. Power on the AP
Installing the AP Management Tools
step1. Insert the InstantWave High Rate CD into the CD-ROM drive and click
Start/Run. Type e:/menu.exe (assuming the CD drive is E) and click
OK to open the InstantWave CD main menu
step2. Click Install AP Management Tools to install the AP COMFig Tool,
AP Management System (APMS) and Trap Server utility to your system