Connecting the supplied power cable – NEC NP110 User Manual
Page 25
16
2. Installation and Connections
Connecting the Supplied Power Cable
Connect the supplied power cable to the projector.
First connect the supplied power cable's three-pin plug to the AC IN of the projector, and then connect the other plug
of the supplied power cable in the wall outlet.
To wall outlet
The projector will go into standby
mode. When in standby mode, the
POWER indicator will light orange
and the STATUS indicator will light
green when [NORMAL] is selected
for [STANDBY MODE].
CAUTION:
Do not try to touch the ventilation outlet on the front side as it can become heated while the projector is turned on
and immediately after the projector is turned off.
Make sure that the prongs are fully inserted into both the
power plug and the wall outlet.