NEC NP110 - Manual (Page 35)

26
3. Projecting an Image (Basic Operation)
7 Turning off the Projector
To turn off the projector:
1. first, press the (POWer) button on the projector
cabinet or the POWer Off button on the remote con-
trol.
The [POWER OFF / ARE YOU SURE? /CARBON SAV-
INGS- SESSION 0.000[g-CO2]] message will appear.
2. secondly, press the enter button or press the
(POWer) or the POWer Off button again.
The lamp will turn off and the projector will go into standby
mode. When in standby mode, the POWER indicator will
light orange and the STATUS indicator will light green when
[NORMAL] is selected for [STANDBY MODE].
Immediately after turning on the projector and displaying an
image, you cannot turn off the projector for 60 seconds.
3. finally, unplug the power cable.
The POWER indicator will go out.
NOTE: Do not unplug the power cable within 10 seconds of making
adjustment or setting changes and closing the menu.
Doing so can cause loss of adjustments and settings.
CAUTION:
Parts of the projector will become heated during operation. Use caution when picking up the projector immediately
after it has been operating.
CAUTION:
The projector cannot be turned off for 60 seconds after the lamp is turned on and while the POWER indicator is
blinking green. Doing so could cause premature lamp failure.
Power On Standby
Steady green light Steady orange light